Tie Road
- SPECIFICATIONS :
- Thread 2.5 TPI
- Golden Electroplated or Self Finish
- 15 / 17 mm OD
- Length upto 6 mtrs.
- Breaking load of 135 KN
Wing Nut Heavy
- SPECIFICATIONS :
- Dywiday Thread
- Wing nuts with two wings, compatible with tie rods. Wing Nuts are a typical component of the Tie bar system and are suitable for both timber and steel from work, when counter plates are used. Zinc plated for rust protection.
Wing Nut Light
- SPECIFICATIONS :
- Made out of Cast Iron Safe Working Load: 90 kN
- Wing Nut available in 15/17
- Finish: Yellow and Zinc Plated
Hex Nut or Tie Road Connector
- SPECIFICATIONS :
- Dywiday Thread
- Wing nuts with two wings, compatible with tie rods. Wing Nuts are a typical component of the Tie bar system and are suitable for both timber and steel from work, when counter plates are used. Zinc plated for rust protection.
Base or Waller Plate
- SPECIFICATIONS :
- Sizes :
- 120 mm X 120 mm X 5/6/8/10 mm
- 150 mm X 150 mm X 5/6/8/10 mm
Water Barrier
- SPECIFICATIONS :
- Water stopper is compatible with 15/17mm tie rods, for achieving water tight ties.Water stoppers are made from high quality casting and have a plastic caps at both ends, special feature is an additional surrounding disc for better Anchoring and further security against penetrating water.
Plastic Cone
- SPECIFICATIONS :
- Located at the ends of the plastic sleeve, cone allows the tie rod to penetrate easily side to another. Available in different colors.
Rapid Clamp
- SPECIFICATIONS :
- Rapid Clamps are used with mild steel rods and provide a cheap, effective clamping system that has no nuts or bolts and leaves no expensive ties in the concrete. Available in blue painted, galvanized or rough finish. The wedge of the clamp is available with heat treatment also for long life.
Anchor Nut
- SPECIFICATIONS :
- Malleable Casting
- Thread 2.5 TPI
- Golden Electroplated or Self Finish
- 15 / 17 mm
Shuttering Clamp
- SPECIFICATIONS :
- Mild Steel for Column Formwork
- Painted Black or Self Finish
- Sizes : 2.1/2", 3", 4"
- 70 CM – 120 CM x 4.50 MM to 8.00 MM
Gogo Clamp
- SPECIFICATIONS :
- Malleable Casting with a Hex Nut of 5/8"
- Self Finish
